Unspecified vulnerability in Cisco TelePresence C Series Endpoints, E/EX Personal Video units, and MXP Series Codecs, when using software versions before TC 4.0.0 or F9.1, allows remote attackers to cause a denial of service (crash) via a crafted SIP packet to port 5060 or 5061, aka Bug ID CSCtq46500.
Unspecified vulnerability in the NAT implementation in Cisco IOS 12.1 through 12.4 and 15.0 through 15.1, and IOS XE 3.1.xSG, allows remote attackers to cause a denial of service (device reload or hang) by sending crafted SIP packets to TCP port 5060, aka Bug ID CSCso02147. Unspecified vulnerability in the NAT implementation in Cisco IOS 12.1 through 12.4 and 15.0 through 15.1, and IOS XE 3.1.xSG, allows remote attackers to cause a denial of service (device reload) by sending crafted SIP packets to UDP port 5060, aka Bug ID CSCti48483. The provider-edge MPLS NAT implementation in Cisco IOS 12.1 through 12.4 and 15.0 through 15.1, and IOS XE 3.1.xSG, allows remote attackers to cause a denial of service (device reload) via a malformed SIP packet to UDP port 5060, aka Bug ID CSCti98219. Memory leak in the NAT implementation in Cisco IOS 12.1 through 12.4 and 15.0 through 15.1, and IOS XE 3.1.xSG, allows remote attackers to cause a denial of service (memory consumption or device reload) by sending crafted SIP packets to UDP port 5060, aka Bug ID CSCtj04672. Siemens Openstage and Gigaset phones use the following ports:ġ8443/TCP and 18444/TCP - provisioning over TLS (HTTPS)
#PORTFORWARD CHECKER CODE#
When prompted, enter the Device Access Code found on your gateway and select Submit.In Application Type, select the option that matches your application.Leave this field blank unless directed to do so from the manufacturer or application. By default, the port will map to the same port you specify in the Port (or Range) From/To entry field. Use the default protocol timeout settings in the Protocol Timeout entry field unless directed to do otherwise by the manufacturer.
Enter the Port or Range you wish to open in the Port (or Range) From/To entry fields.In Application Profile Name, enter the name of the application.Under the listed applications, select Add a new user-defined application.Good to know: To open the port, start with step seven. Sometimes, an application you want to access isn’t listed. Repeat this process until all the ports you want to access have been configured and display in Hosted Applications.In Access Code, enter the Device Access Code located on your gateway.Select the Application from the Application List.If you want to deactivate port forwarding, select Maximum protection – Disallow unsolicited inbound traffic.If you want to activate port forwarding, select the Allow individual application(s) option.In Edit firewall settings for this computer:.Check the cables and wires connected to the gateway and device.Confirm the device is properly connected to the gateway.If the device you want to open up to the Firewall is connected to the gateway but isn't listed: Enter the IP Address of the device you want to open up to the Firewall.If the device you want to open to the Firewall isn't listed: Select the device you want to open to the firewall.If you get a warning message, restart your Wi-Fi gateway.Select Settings, then Firewall, and then Applications, Pinholes and DMZ.
0 kommentar(er)
